Bartlett Controller

[melissabeads]

My DH gave me a new Bartlett controller yesterday and I spent the majority of the evening messing around with it. I am using it on a AIM84BD.

I am pretty sure I have the program set right..now the question is..

After working I want to skip to the next segment to hold the temp. for 1 hour ..etc.
Problem is, I can't seem to get it to skip?

I read that you should press the up arrow and it should read SStP1 and it should return to the second segment. If it does not, press the up arrow again..

Is this right? It doesn't seem to want to skip?? ](*,)

Any advice would be GREAT.. THANKS!

[Just Nancy]

I press the arrow and hold it if I'm not mistaken. It's been about 10 days and the motion is about automatic. I'm just not sure what it is.

I could move my kiln to a plug and give it a try if you need me to.

Good luck.

[melissabeads]

Thanks Nancy..Don't go to all that trouble. Maybe someone else will jump in..Thank you.. I will give that a try this evening if I can't get any more advice.

[paintingwithglass]

My DH gave me a new Bartlett controller yesterday and I spent the majority of the evening messing around with it. I am using it on a AIM84BD.

I am pretty sure I have the program set right..now the question is..

After working I want to skip to the next segment to hold the temp. for 1 hour ..etc.
Problem is, I can't seem to get it to skip?

I read that you should press the up arrow and it should read SStP1 and it should return to the second segment. If it does not, press the up arrow again..

Is this right? It doesn't seem to want to skip?? ](*,)

Any advice would be GREAT.. THANKS!

I have to hit the up arrow once and it starts to scroll the segment and when it gets to SSKP I then hit enter....

[melissabeads]

Ahhhhh..Thanks Fay..I am bound to get now..