Forum: Boro Room
2021-12-16, 7:28am
|
Replies: 11
Views: 10,438
What would you determine was a slow ramp up?
Ok that’s good to know and I kinda had figured as much I just didn’t wanna try and completely ruin what I want so badly to fix. My last question is how slowly should I ramp up from 920 to 1050 like...
|
Forum: Boro Room
2021-12-15, 6:12am
|
Replies: 11
Views: 10,438
My question is at what rate should I heat up a...
My question is at what rate should I heat up a Boro pendant in the kiln before I attempt to fix it on the torch? Does it have to be a slow process up to 1050 or so or can I ramp up full speed without...
|
Forum: Safety
2021-12-14, 4:24am
|
Replies: 11
Views: 9,436
Ventilation Fixed!
Fixed the ventilation situation, it’s nice to know people who work sheet metal and heating/a/c work for a living! They hooked me up on a tiny budget of $4…. Yes that’s correct, $4 is what I had to my...
|
Forum: Safety
2021-11-29, 3:33am
|
Replies: 11
Views: 9,436
Omg! Same smell!
I’m super glad to finally figure this issue out! It’s only been a couple of times I’ve smelled bleach after a session but I will definitely ventilate adequately before I fire up again … so glad to...
|
Forum: Torch Questions
2021-11-28, 2:20pm
|
Replies: 8
Views: 3,232
I’m not sure if this would be the best place to...
I’m not sure if this would be the best place to post my question but I’ve gotta try—
After I’m done with a session on my torch ( Beth bravo 3 oxy cons and propane) for some reason it always smells...
|