Lampwork Etc.
 
Send a PM to CorriDawn!

LE Live Chat

Enter Live Chat

No users in chat




Glacial Art Glass


 

Go Back   Lampwork Etc. > Search Forums

Showing results 1 to 25 of 497
Search took 0.62 seconds.
Search: Posts Made By: Baywinger
Forum: Customer Service Kiosk 2016-09-12, 12:57am
Replies: 13
Views: 10,912
Posted By Baywinger
Arrow Springs has it, I found it fits right into...

Arrow Springs has it, I found it fits right into the holder on the blast shield marver, for those just starting out the blast shield marver can be ordered with just the mountings no glass
ACE Sheet...
Forum: Boro Room 2016-09-11, 11:44am
Replies: 30
Views: 20,479
Posted By Baywinger
a note about the minor and boro color vs other...

a note about the minor and boro color vs other torches, I started on a mega minor and have uses minors in classes, I have noticed the nortel torches tend to run to a reducing flame even when run on...
Forum: Boro Room 2016-09-11, 11:38am
Replies: 30
Views: 20,479
Posted By Baywinger
Kristen the holding tank should help you out as...

Kristen the holding tank should help you out as well we run our m20's into an 11 gal holding tank to feed the alpha center fire on our bravo and champ torches works great on boro.
Forum: Customer Service Kiosk 2016-09-11, 11:30am
Replies: 13
Views: 10,912
Posted By Baywinger
I bought a piece of diddy glass and replaced the...

I bought a piece of diddy glass and replaced the clear blast shield piece when working soft glass.
Forum: Torch Questions 2016-09-09, 4:31pm
Replies: 21
Views: 24,273
Posted By Baywinger
actually used and owned both torches

I realize this is a very old thread but someone else may want this answer as well, Nikki may jump in here as well as the scorpion is/was hers however I have used it some myself.

The Scorpion is a...
Forum: Beads of Courage 2015-02-02, 11:35am
Replies: 34
Views: 21,321
Posted By Baywinger
I am in again :-)

I am in again :-)
Forum: Tips, Techniques, and Questions 2014-07-08, 10:29pm
Replies: 51
Views: 13,265
Posted By Baywinger
mine is on my left side, since my bench is back...

mine is on my left side, since my bench is back to back with my wife's that way our kilns are not back to back and on the same circuit. honestly though I am mostly doing off mandrel soft glass...
Forum: Studio 2014-07-04, 11:37pm
Replies: 3
Views: 3,597
Posted By Baywinger
if you have the original paperwork from your...

if you have the original paperwork from your torch it should have the recommended PSI settings for fuel usually around 5 psi and oxygen any where from 5-10psi for that size torch
Forum: Torch Questions 2014-06-19, 12:21pm
Replies: 29
Views: 9,147
Posted By Baywinger
only worked on a lynx at one of the Gatherings,...

only worked on a lynx at one of the Gatherings, MY cheetah had a nice fine point but the 13 ports never could get that small without bad carbon build up even with the blue valve which I uses a lot,...
Forum: Torch Questions 2014-06-18, 4:53pm
Replies: 29
Views: 9,147
Posted By Baywinger
have you tried running just the oxy from the...

have you tried running just the oxy from the outer fire to tighten up the champ inner fire?
Forum: Torch Questions 2014-06-17, 2:22pm
Replies: 29
Views: 9,147
Posted By Baywinger
I am able tp get decent fire power out of the...

I am able tp get decent fire power out of the champ using 3 m20's linked together which supply 30 liters of O2 at 20 psi per min. in discussions with Bethlehem to get the maximum you need to supply...
Forum: Torch Questions 2014-06-17, 9:14am
Replies: 29
Views: 9,147
Posted By Baywinger
are you any where near the SF North Bay area? if...

are you any where near the SF North Bay area? if you are you can stop by my studio and see how you like the champ on both on concentrators and tanks
Forum: Torch Questions 2014-06-17, 9:10am
Replies: 29
Views: 9,147
Posted By Baywinger
I have recently switched from a GTT cheetah too...

I have recently switched from a GTT cheetah too the Beth Champion I find I like how how the Beth flame works the colors both soft and boro better than the GTT flame while I did like the triple mix...
Forum: Torch Questions 2014-06-16, 12:16pm
Replies: 8
Views: 6,981
Posted By Baywinger
for small torches or at least small volumes of...

for small torches or at least small volumes of fuel use tees after the reg should be fine, I just got a tee for before the reg from mountain glass arts so I can regulate the fuel to both Nikki's...
Forum: Torch Questions 2014-06-16, 9:48am
Replies: 23
Views: 9,719
Posted By Baywinger
you can often get the holding tanks from harbor...

you can often get the holding tanks from harbor freight, then it is very simple to modify the tank to feed the oxy cons into the tank to feed your torch, the oxy cons can simply be teed together...
Forum: Torch Questions 2014-06-15, 11:00pm
Replies: 23
Views: 9,719
Posted By Baywinger
my apologies I was looking at the info for the...

my apologies I was looking at the info for the lynx hand torch not the lynx bench torch
INSTRUCTIONS FOR LYNX HAND TORCHES:

 Set Propane Tank Regulator to 10 lbs. of pressure.

 Set...
Forum: Torch Questions 2014-06-15, 5:16pm
Replies: 23
Views: 9,719
Posted By Baywinger
two m20's would be better

two m20's would be better
Forum: Torch Questions 2014-06-15, 3:51pm
Replies: 23
Views: 9,719
Posted By Baywinger
as for lighting your torch with an oxy con I just...

as for lighting your torch with an oxy con I just turn down the open oxygen valve till it is barely on turn on the propane light it then adjust the flame
Forum: Torch Questions 2014-06-15, 3:49pm
Replies: 23
Views: 9,719
Posted By Baywinger
the recommended oxy pressure for the lynx from...

the recommended oxy pressure for the lynx from GTT is to your Set Oxygen Regulator to 25 to 30 lbs. of pressure.
the ex 15 only supplies 15 psi
Forum: Torch Questions 2014-06-14, 10:48am
Replies: 23
Views: 9,719
Posted By Baywinger
What torch are you running and what is it's oxy...

What torch are you running and what is it's oxy requirement?
oxy cons only supply a certain amount of oxygen and you have to buy either larger units or chain units together to supply large amounts...
Forum: Studio 2014-06-10, 7:45pm
Replies: 7
Views: 4,339
Posted By Baywinger
Hers and His studio

just got our new Benches up with individual ventilation as well as a powered ceiling vent. all the vent fans and the lights are on remote control.
Nikki also has a rolling mill on hers from her...
Forum: Torch Questions 2014-06-10, 2:50pm
Replies: 29
Views: 9,147
Posted By Baywinger
the Bethlehem bravo and champion are very nice...

the Bethlehem bravo and champion are very nice and versatile torches
Forum: Studio 2014-06-10, 9:58am
Replies: 10
Views: 5,995
Posted By Baywinger
I am in the middle of building us a new his and...

I am in the middle of building us a new his and hers set up, before we had just set up on benches in the garage that where for other hobbies or general use, these new ones are face to face dedicated...
Forum: Studio 2014-06-10, 7:59am
Replies: 14
Views: 7,723
Posted By Baywinger
I too recommend the glass hive kiln, a 120 kiln...

I too recommend the glass hive kiln, a 120 kiln is fine unless you need a large kiln though as a beginner that is unlikely. Bethlehems are great torches I just upgraded too a champion and it is a...
Forum: Studio 2014-06-10, 7:24am
Replies: 2
Views: 2,675
Posted By Baywinger
this is the model you would need ...

this is the model you would need
http://jenkenkilns.com/beadsandlampworking.aspx
Showing results 1 to 25 of 497

 
Forum Jump



All times are GMT -7. The time now is 5:49am.


Powered by vBulletin® Version 3.7.5
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Your IP: 18.212.102.174