Thread: Enamels!
View Single Post
  #15  
Old 2008-03-09, 11:25am
Mustang Dawn's Avatar
Mustang Dawn Mustang Dawn is offline
Your Royal Fritness
 
Join Date: Jun 13, 2005
Location: Howell, Michigan
Posts: 3,392
Default

Quote:
Originally Posted by redbearmountain View Post
Dawn, How does the sifter work? When do you stencil the enamel on, bead can't be hot it would melt the stencil! Would you please explain how that works?
Sure I can,

I use a brass stencil and place it on my marver. Then I use my little red sifter (see picture) and lightly sift the enamel over the stencil. Next carefully lift your stencil off of the marver not to disturb the design. Make your bead and then roll or place your bead on your stencil design. The heat never touches your stencil.

This all needs to be done under your ventilation system.

I all ways clean up my work area after with a damp paper towel.

Dawn
Attached Images
 
__________________

To view links or images in signatures your post count must be 5 or greater. You currently have 0 posts.


To view links or images in signatures your post count must be 5 or greater. You currently have 0 posts.


To view links or images in signatures your post count must be 5 or greater. You currently have 0 posts.

Last edited by Mustang Dawn; 2008-03-09 at 11:30am.
Reply With Quote