View Single Post
  #1  
Old 2013-11-01, 8:52am
blueburnsorange blueburnsorange is offline
Junior Member
 
Join Date: Sep 19, 2013
Posts: 18
Default What are the best options for terminating the exhaust run?

Meaning, I've pretty much built my exhaust system from the work table to the inside wall but I've yet to cut my hole to the outside yet. I don't know how I want to protect the exhaust duct from outside elements...

Blast Gate (Blast Shield): I'm probably going to put a blast gate between the inline fan and the exterior wall so I can seal everything off when I'm not working. I've ordered this one: http://www.blastgateco.com/Cast-Alum...last-Gates.php

Dampeners:
are not something I want because it reduces airflow

End-Caps/Register boxes: so what do you guys put on the exterior walls of your studio? If I use an dryer-style end-cap (even one without a built-in dampener) should I be concerned about airflow restriction?

Last edited by blueburnsorange; 2013-11-01 at 9:18am.
Reply With Quote