I have the instructions, but the files are too big to upload to LE, and I'm not sure how far I can reduce the size without making them unreadable. I can email the files on request.
The procedure is not what I thought. I imagined that the purpose of the large handle was to make twisting the pull easier, if desired.
The glass rods included are boro. The aluminum bracket is fastened or clamped to a table. After the murrine is built, the free end is attached to the boro rod with the handle installed. Then the handle is placed in the bracket through a slot.
I haven't found my cane vise yet to give feedback on how well that works.
|