Quote:
Originally Posted by redbearmountain
Dawn, How does the sifter work? When do you stencil the enamel on, bead can't be hot it would melt the stencil! Would you please explain how that works?
|
Sure I can,
I use a brass stencil and place it on my marver. Then I use my little red sifter (see picture) and lightly sift the enamel over the stencil. Next carefully lift your stencil off of the marver not to disturb the design. Make your bead and then roll or place your bead on your stencil design. The heat never touches your stencil.
This all needs to be done under your ventilation system.
I all ways clean up my work area after with a damp paper towel.
Dawn