View Single Post
  #17  
Old 2017-12-29, 6:37am
fourpawsglass's Avatar
fourpawsglass fourpawsglass is offline
Senior Member
 
Join Date: Sep 04, 2005
Location: Sterling, VA
Posts: 442
Default

Since no one actually answered your question - I will. After you have placed your dots on the maria and imploded them, get the back of the maria hot enough to make the glass move, then take a cold rod of glass (I like to use a smaller mm size - say around 4mm) and stab into the middle of your circle of dots (don't go too deep - just on the surface) and give it a half twist. Let the smaller rod cool and snap it off (wiggle back and forth until the glass snaps). Resmooth the back of the maria. You can then put on your backing color.
Reply With Quote