Thread: Kiln issues
View Single Post
  #2  
Old 2016-01-17, 6:32am
GregD GregD is offline
Junior Member
 
Join Date: Aug 25, 2015
Location: Fort Wayne, IN
Posts: 14
Default

I had a problem once because the screws that clamp the thermocouple to the wires. If you have a continuity tester or ohm meter you can check that the thermocouple looks like a short. Only do this after dicnonnecting one of the wires to the controller. You might be able to see if the thermocouple is broken inside the kiln
Reply With Quote