View Single Post
  #5  
Old 2014-07-20, 6:04am
Dale M.'s Avatar
Dale M. Dale M. is offline
Gentleman of Leisure
 
Join Date: Jun 10, 2005
Location: A Little Bit West of Yosemite Valley
Posts: 5,200
Default

Your torch has standard welding hose connectors that are left hand (counter clockwise) thread for fuel and right hand thread (clockwise) for oxygen.......





The small grooves in hex area of hose nuts designates left hand thread...

Any good (commercial) welding supply should be able to help you.... You can also get welding "twin hose" and separate it to run to fuel regulator and concentrator... Concentrator if threaded connection should be same as welding hose but right hand thread.... Plastic barb on concentrater should unscrew and there should be standard welding hose threaded fitting under it...

Be sure hose is type 'T' which is all fuel approved, type "R" is for acetylene only...

Dale
__________________
You can lead a person to knowledge, but you can't make them think.

To view links or images in signatures your post count must be 5 or greater. You currently have 0 posts.
Vendor-Artist-Studio-Teacher Registry

To view links or images in signatures your post count must be 5 or greater. You currently have 0 posts.
San Francisco - A Few Toys Short of a Happy Meal

Last edited by Dale M.; 2014-07-20 at 6:09am.
Reply With Quote