I finished the GA sample project kit yesterday, and made the following things. (The Marble is really wonky because I started running out of OXY during it and had to finish it quickly.) However, on the bead that I made the closeup of I used GA Triple Passion and coverd it with some dots of clear. I flame stuck it so that the entire bead was a light purple color and garaged it at 975 degrees, after everything was done I ramped the kiln up to 1050 degrees and held it for about 40 minutes. When I pulled them out I noticed that the while the color under the clear dots was pretty close to what I started with, the outside color had gone very dark. Any tips on how I can prevent this next time? Mr. Smiley you out here?
