View Single Post
  #10  
Old 2018-01-28, 7:07pm
Fuzzy Fuzzy is offline
Junior Member
 
Join Date: Jan 23, 2018
Location: FL
Posts: 27
Default

ya im def seeing that patience is required to get started but i'm excited about taking the steps to do it right and be safe. I'll get shed, build workbench, setup torch, build the ventilation, keep looking for a used kiln. I'm also looking at attaching a digital controller to an analog. Thanks for the info on oxycons, i've been reading about them now. I've decided to go with tanked o2 to start since its only $9/mnth + $26 refills and the Lynx should be efficient. Maybe a couple oxycons will be in the cards a few paydays down the road. Maybe i could afford them if i turn a toaster oven into a kiln. ��
Either way i'll have the shed soon and i have an electrician friend that's gonna run it on it's own breaker. I'm thinking all outlets on left, kiln on it's own table on the left, torch facing back wall of shed, propane outside left wall and o2 chained up on the right close to the door. Thanks again guys for all the info. I'll be around.
Reply With Quote