Quote:
Originally Posted by jaci
What about a clear silicone caulk? Flare when still not set. Just apply a small amount under the bead cap on the inside and the edge where it will be faired?
|
^^^^
There are a couple of other options.
1. make it on the end of a blow tube so you only have one end to deal with. I found the tubing to be pretty unattractive inside of the hollow plus, it takes up quite a bit of your room so you don't have as much space to fill it with the fun stuff. Find a large enough bead cap and silicon or glue the head pin in and then silicon the bead cap to the bead.
2. make a hollow bead on a 3.2 mm mandrel so you have a smaller hole and proceed as above.