View Single Post
  #2  
Old 2017-03-08, 5:39pm
ESC ESC is offline
Senior Member
 
Join Date: Feb 02, 2010
Posts: 2,243
Default

Bea, I've always made flat ribbon by welding two or three pieces of rod, about an inch in length to each other, side by side. Have the middle rod attached to a punty, get all two/three pieces hot enough to flatten, attach another punty to the other end. Heat up enough again to pull. You don't get a really long piece of flat ribbon, but usually you don't need a really long piece of ribbon. Does this help?
__________________
ESC
Soft glass on a Minor/concentrator since 1996
Reply With Quote