View Single Post
  #19  
Old 2021-01-06, 6:02am
SGA's Avatar
SGA SGA is offline
Fried Cat
 
Join Date: Jan 02, 2011
Posts: 665
Default

Do you mean this twist?

Super simple. You have the idea of a gravity bead. It takes a little prep. Pull clear rods of glass to fine sharp points, 2mm or so. Set to the side.

After you use your sharp edge, encase and let gravity do it’s thing, you spot heat, not soupy but soften. Poke your clear glass tool into the middle, twist or roll the clear rod in your fingers, like you’re spinning a pencil. Let cool, snap off and melt smooth.

It takes a little bit to figure out how soft, how quick, how thick you want the twist.
Attached Images
 
Reply With Quote