Pipe to enclose Hoses

[BBB]

OK This is probably a stupid thing to do but I would like to Put pipe threw the wall where the O2 and the Prop will come in but I am not sure what type of pipe to use.
Also, there is a 6 foot run from where the pipe enters the building until where the torche is so I would like to run the hoses in the hard pipe most of that way. Anyone see anything wrong with that?
Finally, if I do run the hoses in the long pipe, should the pipe be angled towards the Torch or away? I would thinkg away since Prop in heavy.
D

PS I will actully run 2 pipes, one for the O2 and 1 for the Prop

[theglasszone]

DUDE!!! (or DUDETTE, as the case may be)................

Check this thread!!! You best rethink what you are hoping to do - I had this idea as well. Once you get though this thread, though, maybe (hopefully!) you will change your mind and do it the RIGHT WAY:

http://www.lampworketc.com/forums/sh...ad.php?t=96149

Definitely pay attention to the first thread, of course - but especially Post #s 8, 14 and the one I just posted, #49.

BETTER SAFE THAN SORRY!

Good luck~
DeAnne in CA