Programming the Partlow 1166 controller in the Fusebox II Kiln from EK Miller

[meganlee]

Hi all!! I have just acquired a Fusebox II from a relative for annealing my glass beads. She did not have a manual for the kiln or the controller and did not recall what programs she had previously set. I am trying to avoid having to sit and watch a program run through its cycle just so I know what it's doing!

I would like to set an annealing cycle for the following:

950 to 880 in 1hr, hold 15mins
880 to 780 in 1hr, hold 15mins
780 to 680 in 1hr, hold 15mins
680 to 580 in 1hr, hold 15mins
then shut off to cool to room temp

Any guidance would be much appreciated, maybe someone has or had this kiln and could walk me through setting the program above? I found the controller manual online but it is hard to follow! A whole lot of push these 2 buttons at once, while doing this, etc etc and they don't define the acronyms used in the display very well.

Thanks so much!!