Rose Murrini Tutorial by Smiltroy
Hi there and welcome to my rose
murrini tutorial, in this tutorial I will show you how I apply my rose
murrini that you can buy in my etsy shop:
http://www.etsy.com/shop/Smiltroy .
I use 3 different techniques to apply them, depending on what look I want to use, in this tutorial I will show you how to achieve the 3 different looks and give you some example photos of each style.
You can also download a printable tutorial on my website:
http://www.smiltroy.org/murrini.html
Melted In Rose Murrini Method
1 Spot Heat the bead very well in the place where youre going to put the
murrini, while you pre-heat the
murrini chip by waving it in the top of the flame.
2 Place the
murrini chip by pushing it into the bead to the point where the top of the
murrini is at the same level as the bead surface (Image 1)
3 Add a good dot of transparent on top of the
murrini (Image 2)
4 Heat the transparent dot and start pushing it down softly, heat/push/heat/push (Image 3)
5 Continue to push the transparent heating the bead as well so when you do the final push no air is trapped on the sides of the
murrini (Image 4 & 5)
Image1
Image2
Image3
Image4
Image5
Example:
Spread Out Rose Murrini Method
1 Spot Heat the bead very well in the place where youre going to put the
murrini, while you pre-heat the
murrini chip by waving it in the top of the flame.
2 Place the
murrini on the surface of the bead without pushing it very hard (Image 1)
3 Add a good dot of transparent on top of the
murrini (Image 2)
4 Heat the transparent dot AND the
murrini and start pushing it down very softly, (image 3) heat/push/heat/push until it start to look like a mushroom (image 4)
5 Continue to heat both the
murrini and transparent and take a razor or something sharp like that and start to spread out the
murrini all the way around, by pulling it very softly away from the center of the transparent dot towards the base of the bead, very carefully to not ruin the design. (Image 5) Make sure you pull the transparent all the way around the
murrini so the transparent covers the entire
murrini (Image 6)
Image1
Image2
Image3
Image4
Image5
Image6
Example:
Blooming Rose Murrini Method (my favorite =P)
1 Spot Heat the bead very well in the place where youre going to put the
murrini, while you pre-heat the
murrini chip by waving it in the top of the flame.
2 Place the
murrini chip by pushing it into the bead just a little, like half-way (Image 1)
3 Add a good dot of transparent on top of the
murrini (Image 2)
4 Heat the transparent dot AND the
murrini and start pushing it down very softly, (image 3) heat/push/heat/push until it start to look like a mushroom (image 4)
5 Continue to heat both the
murrini and transparent and pushing it until the transparent covers the entire
murrini. Leave raised for amazing depth (Image 5)
Image1
Image2
Image3
Image4
Image5
Example: